Clarke SB30 Инструкции пользователя - Страница 7

Просмотреть онлайн или скачать pdf Инструкции пользователя для Электроинструмент Clarke SB30. Clarke SB30 13 страниц. Sand blast cabinet

CAUTION: SHOULD ANY ABRASIVE BE SPILLED, ENSURE IT IS CLEANED UP

IMMEDIATELY, AS ITS SLIPPERY PROPERTIES CAN BE EXTREMELY HAZARDOUS.

REPLACING THE ABRASIVE NOZZLE

Ensure the air supply is disconnected before performing this operation.

1. Pull the trigger of the gun as a precautionary measure.

2. Unscrew the end cap and withdraw the ceramic nozzle.

3. Replace with the nozzle of your choice and carefully thread the end cap

back on to the gun, taking great care NOT to cross thread the fine thread.

NOTE: Should it be necessary to change the air nozzle, first remove the

abrasive nozzle as described above. A box spanner will be

required to unscrew and withdraw the air nozzle.

MAINTENANCE

Before use, check to ensure that all parts are serviceable, including the air

inlet hose, rubber gloves. and abrasive pick up.

The door securing clamp must be perfectly serviceable so as not to allow the

door to open during operation. The build up of air pressure within the cabinet

could force the door open, allowing abrasive to escape. This is not only

wasteful, but could be a health hazard.

Change the window protective film should visibility be impaired. Simply peal

off the old film and replace with a new one. Replacement protection film is

available from your Clarke dealer.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]