Clarke SB30 Инструкции пользователя - Страница 9
Просмотреть онлайн или скачать pdf Инструкции пользователя для Электроинструмент Clarke SB30. Clarke SB30 13 страниц. Sand blast cabinet
Печатать страницу
TROUBLESHOOTING
Problem
Excessive dust in the
cabinet.
Uneven blasting
action
Inadequate speed or
inefficient blast.
Static electricity
present
Excessive media
blown into the
surrounding
SPECIFICATION
Max Air Supply.................................10psi (7 bar)
Min Air Delivery................................10 CFM
Electrical Power Supply.................230V 50 Hz 1 ph
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Check
No dust extract device
used.
Air vent or overflow
blocked.
Abrasive media worn.
Too much abrasive media in
the cabinet.
Loose airline or loose
connections.
Too much abrasive media in
the cabinet.
Abrasive is damp.
Moisture present inside
cabinet.
Abrasive media worn.
Pressure too low.
Dry weather conditions.
Door not secure.
9
Solution
Install dust extract
device.
Clean rear vent and
keep vent away from
any wall.
Replace abrasive media
Remove excessive
media.
Tighten fittings and
ensure airline is secure.
Remove excessive
media.
Renew abrasive or dry
thoroughly before use.
Check airline to ensure it
is free from moisture.
Replace abrasive media
Increase inlet pressure
and ensure control valve
is fully open.
Leave the item to be
cleaned on the grid.
Secure the door with the
clip provided.