Zanussi ZU 7115 Буклет с инструкциями - Страница 6

Просмотреть онлайн или скачать pdf Буклет с инструкциями для Холодильник Zanussi ZU 7115. Zanussi ZU 7115 16 страниц. Larder-refrigerator
Также для Zanussi ZU 7115: Буклет с инструкциями (20 страниц)

Печатать страницу

Door reversibility

Fig. 3

Remove the two screws which fix the upper

hinge to the door.

Carefully lean the appliance on its back and

remove the plastic insert (Fig. 3).

Remove the two screws which fix the lower

hinge to the door.

Remove the four screws which fix the lower

hinge to the base of the appliance and remove

the hinge itself; be very careful to recover all the

screws.

D447

Remove the four screws that fix the upper hinge

to the appliance and remove the hinge itself.

Take the hinge removed from the upper part of

the appliance on the opposite side (see Fig. 4),

Fig. 4

and, using the screws removed from the lower

part, fix it to the base of the appliance itself.

Remove and refit the other hinge on the upper

part of the appliance on the opposite side.

Fix the two front screws into the upper and

lower hinges (Fig. 4).

Finally, check the alignment of the door and

make sure it closes properly.

After having reversed the opening direction of

the door, discard the original plastic insert

D510

removed and fit the insert supplied with the

appliance on the opposite side.

Fitting a decorative door panel

Important: The componente needed to fit the

decorative panel trave been pre-fitted on the

appliance.

The brackets are secured to the panel by

means of the 7 Ø 3.5x13 screws supplied.

Before starting to fit the panel, remove the

large top bracket by unscrewing the screws

and adjusffng pins pre-fitted on the

appliance door.

The small bottom bracket need not be

removed.

Place the appliance in the position where it is to

Fig. 5

be built in (Fig. 5).

The appliance is fitted with adjustable feet;

screw the front and rear feet in or out to adjust

the height of the appliance to that of the recess.

Keeping the appliance central in the recess,

slide it in until its back touches the wall.

Wıth a tape measure (or similar instrument),

measure distance (A) between the top edge of

the door and the top edge of the decorative

panel, placing it next to the recess.

D467