Zanussi ZU 7115 Talimat Kitapçığı - Sayfa 6
Buzdolabı Zanussi ZU 7115 için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Zanussi ZU 7115 16 sayfaları. Larder-refrigerator
Ayrıca Zanussi ZU 7115 için: Talimat Kitapçığı (20 sayfalar)
![Zanussi ZU 7115 Talimat Kitapçığı](/uploads/products/server2/7120014/7120014.png)
Door reversibility
Fig. 3
Remove the two screws which fix the upper
hinge to the door.
Carefully lean the appliance on its back and
remove the plastic insert (Fig. 3).
Remove the two screws which fix the lower
hinge to the door.
Remove the four screws which fix the lower
hinge to the base of the appliance and remove
the hinge itself; be very careful to recover all the
screws.
D447
Remove the four screws that fix the upper hinge
to the appliance and remove the hinge itself.
Take the hinge removed from the upper part of
the appliance on the opposite side (see Fig. 4),
Fig. 4
and, using the screws removed from the lower
part, fix it to the base of the appliance itself.
Remove and refit the other hinge on the upper
part of the appliance on the opposite side.
Fix the two front screws into the upper and
lower hinges (Fig. 4).
Finally, check the alignment of the door and
make sure it closes properly.
After having reversed the opening direction of
the door, discard the original plastic insert
D510
removed and fit the insert supplied with the
appliance on the opposite side.
Fitting a decorative door panel
Important: The componente needed to fit the
decorative panel trave been pre-fitted on the
appliance.
The brackets are secured to the panel by
means of the 7 Ø 3.5x13 screws supplied.
Before starting to fit the panel, remove the
large top bracket by unscrewing the screws
and adjusffng pins pre-fitted on the
appliance door.
The small bottom bracket need not be
removed.
Place the appliance in the position where it is to
Fig. 5
be built in (Fig. 5).
The appliance is fitted with adjustable feet;
screw the front and rear feet in or out to adjust
A
the height of the appliance to that of the recess.
=
=
Keeping the appliance central in the recess,
slide it in until its back touches the wall.
Wıth a tape measure (or similar instrument),
measure distance (A) between the top edge of
the door and the top edge of the decorative
panel, placing it next to the recess.
D467
6