Zanussi FE 4000 Инструкция по использованию и уходу - Страница 9
Просмотреть онлайн или скачать pdf Инструкция по использованию и уходу для Стиральная машина Zanussi FE 4000. Zanussi FE 4000 36 страниц. Front-load washing machine
Также для Zanussi FE 4000: Руководство по эксплуатации и уходу (36 страниц)
Печатать страницуIf only a cold water supply is available,
connect the two hoses to a cold water
outlet by means of a "Y" connection piece.
Installation should comply with local
water authority and building regulations'
requirements.
The appliance must be given a separate
cold water supply and not be connected to
a mixer tap, a single outlet water heater
or a booster pump. A minimum water
pressure of 7 psi is required for the safe
operation of the appliance.
If you cannot make the cold water
connection direct from the rising mains,
you may be able to operate the appliance
from your cold water storage system.
There should be a minimum distance of
5.02 m (16.5 ft) between the appliance's
inlet and the bottom of the tank.
There will be sufficient pressure for the
hot water supply from the hot water
cylinder if the height between the
appliance's inlet and the bottom of the
cold water storage cistern (not between
the appliance and hot water cylinder) is at
least 2.74 m (9 ft).
If you are operating the appliance on the
minimum pressure of 7 psi, it may fill
slowly. This flow can be increased by
removing the small restrictor contained
within the inlet valve. In order to remove
the restrictor, first turn the water off and
unplug the appliance. Disconnect the
water supply hose from the inlet valve,
pull out the mesh filter inside the valve.
Remove the restrictor (which is a small
round washer) with the aid of thin-nosed
pliers. Replace mesh filter and re-fit hose.
If you intend the drain hose from the
machine to empty into a sink, make sure
the sink is empty and that the plug hole
is not blocked.
Where the machine is permanently
plumbed in, hook the end of the
hose into a standpipe installed for the
purpose. It should have an internal
diameter of at least 38mm (11⁄2") thus
leaving an air gap between hose and
pipe, and should be designed in such a
way that the water level within it never
covers the end of the hose.