- ページ 9

洗濯機 Zanussi FE 4000のPDF 使用上の注意をオンラインで閲覧またはダウンロードできます。Zanussi FE 4000 36 ページ。 Front-load washing machine
Zanussi FE 4000 にも：取扱説明書 (36 ページ)

ページを印刷する

If only a cold water supply is available,

connect the two hoses to a cold water

outlet by means of a "Y" connection piece.

Installation should comply with local

water authority and building regulations'

requirements.

The appliance must be given a separate

cold water supply and not be connected to

a mixer tap, a single outlet water heater

or a booster pump. A minimum water

pressure of 7 psi is required for the safe

operation of the appliance.

If you cannot make the cold water

connection direct from the rising mains,

you may be able to operate the appliance

from your cold water storage system.

There should be a minimum distance of

5.02 m (16.5 ft) between the appliance's

inlet and the bottom of the tank.

There will be sufficient pressure for the

hot water supply from the hot water

cylinder if the height between the

appliance's inlet and the bottom of the

cold water storage cistern (not between

the appliance and hot water cylinder) is at

least 2.74 m (9 ft).

If you are operating the appliance on the

minimum pressure of 7 psi, it may fill

slowly. This flow can be increased by

removing the small restrictor contained

within the inlet valve. In order to remove

the restrictor, first turn the water off and

unplug the appliance. Disconnect the

water supply hose from the inlet valve,

pull out the mesh filter inside the valve.

Remove the restrictor (which is a small

round washer) with the aid of thin-nosed

pliers. Replace mesh filter and re-fit hose.

If you intend the drain hose from the

machine to empty into a sink, make sure

the sink is empty and that the plug hole

is not blocked.

Where the machine is permanently

plumbed in, hook the end of the

hose into a standpipe installed for the

purpose. It should have an internal

diameter of at least 38mm (11⁄2") thus

leaving an air gap between hose and

pipe, and should be designed in such a

way that the water level within it never

covers the end of the hose.