Zanussi ZGG65414 Руководство пользователя - Страница 11

Просмотреть онлайн или скачать pdf Руководство пользователя для Варочная панель Zanussi ZGG65414. Zanussi ZGG65414 16 страниц.
Также для Zanussi ZGG65414: Руководство пользователя (16 страниц), Руководство пользователя (21 страниц), Руководство пользователя (16 страниц)

Zanussi ZGG65414 Руководство пользователя
• This appliance is supplied with a mains
cable. It has to be supplied with a correct
plug which can hold the load that the rating
plate rates. Make sure that you install the
plug in a correct socket.
• Always use a correctly installed shockproof
socket.
• Make sure that there is an access to the
mains plug after the installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
• There is a risk of fire when the appliance is in
connection with an extension cable, an
adapter or a multiple connection. Make sure
that the ground connection agrees with the
standards and regulations.
• Do not let the power cable to heat up to a
temperature higher than 90° C.
Make sure that you connect the blue
neutral cable to the terminal with a
letter "N" on it. Connect the brown
(or black) phase cable to the
terminal which has a letter "L". Keep
the phase cable connected at all
times.
Connection cable
To replace the connection cable use only the
special cable or its equivalent. The cable type
is: H05V2V2-F T90.
Make sure that the cable section is applicable
to the voltage and the working temperature. The
yellow / green earth wire must be approximately
2 cm longer than the brown (or black) phase
wire.
Building In
min. 100 mm
min. 55 mm
30 mm
www.zanussi.com
A) supplied seal
B) supplied brackets

Possibilities for insertion

The panel installed below the hob must be easy
to remove and let an easy access in case a
technical assistance intervention is necessary.
Kitchen unit with door
min. 650 mm
560 mm
A) Removable panel
B) Space for connections
10 mm
3 mm
CAUTION!
Install the appliance only on a
worktop with flat surface.
A
60 mm
B
A
11 mm
11 mm
A
B
30 mm
min 20 mm
(max 150 mm)
11