Aleko Victoria Series Руководство по установке - Страница 14

Просмотреть онлайн или скачать pdf Руководство по установке для Аксессуары Aleko Victoria Series. Aleko Victoria Series 20 страниц. Sizes 6.5x5 8x6.5 10x8
Также для Aleko Victoria Series: Инструкции по установке и эксплуатации (12 страниц), Руководство по сборке (14 страниц), Руководство по установке (17 страниц)

STEP 2: Drilling the Bolt Holes

1. Now that you have a straight, level line across the wall with the locations

of the wall brackets and their bolt holes marked, you will drill holes to

mount the brackets.

2. Using a 16mm masonry drill bit, drill the first bolt hole approximately

4 inches (9 centimeters) deep, as shown in the diagram. This must be

drilled through solid brick or concrete to offer the necessary support for

the awning.

3. Drill the remaining holes exactly as in step 2.

IMPORTANT: All bolt holes must be aligned vertically and horizontally to ensure

that the awning hangs straight.

Double check alignment before drilling if you are not certain.

IMPORTANT: The diameter and depth of your mounting holes must be the same

size as the expansion bolts.

STEP 3: Preparing For Mounting

1. Now that all of your holes are drilled, insert the expansion bolts.

2. It may be necessary to drive the bolts in with a wooden (or other non-metallic) mallet.

If a mallet is necessary for installation, we recommend placing the nut on the screw

(loosely) before hammering to avoid damaging the bolt threads.

3. Make sure that the bolts are firmly in place, yet let them stick out of the wall approximately 1 inch or less - enough

that the wall bracket can be installed onto them.

4. Firmly tighten the bolts with a 19mm hex key. It is best to use the hex key with a closed end rather than an open end

to avoid damaging the nut, should it slip.

Spring washer

Expansion bolt

Washer

Nut

Bolt

Drill 9 cm (~4') deep