Clarke CMS 200 Инструкции по эксплуатации и техническому обслуживанию - Страница 14

Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Сандер Clarke CMS 200. Clarke CMS 200 18 страниц. 3 in1 multi sander
Также для Clarke CMS 200: Руководство по эксплуатации и техническому обслуживанию (17 страниц)

2. Remove the four bolts shown at F, Fig.9, and remove the Upper Blade

Guard Cover.

3. With the cover removed, unscrew the blade securing bolt, with its

washer, completely. Pull off the outer flange, and then the blade.

(Take great care when handling the blade).

You should take this opportunity to clean the inside of the blade guard

of any dust build-up and check generally for security of parts.

NOTE: This machine is capable of accepting blades with bores of 18 and

20mm.

4. Check the bore of your

replacement blade. If it is the

same as the blade you are

replacing, simply mount it on

to the boss of the inner flange

shown in fig. 10, with the

blade tips facing down at the

front. Ensure the parts are

perfectly clean, and the

blade sits snugly on the boss.

5. Replace the outer flange

followed by the securing bolt

with washer - remembering

the bolt has a left hand thread. Leave the bolt finger tight.

6. Replace the upper blade guard cover and securing bolts (F). Tighten

the bolts, but do not overtighten them as this could strip the threads

NOTE:

If you are replacing a 18mm bore blade with an 20mm bore blade, or

vice versa, it will be necessary to pull off the inner flange from the motor

shaft, turn it through 180° and then replace it. The correct boss will now

face outwards allowing you to properly mount the new blade.

7. With the upper blade guard cover secure, tighten the blade securing

bolt using the peg and socket spanners and provided. Do not

overtighten and DO NOT use extensions to the socket spanner lever.

NOTE: The use of HSS blades is NOT recommended.

Fig.10