Clarke CMS 200 Instrucciones de uso y mantenimiento - Página 14
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Sander Clarke CMS 200. Clarke CMS 200 18 páginas. 3 in1 multi sander
También para Clarke CMS 200: Manual de instrucciones de uso y mantenimiento (17 páginas)
Imprimir página
2. Remove the four bolts shown at F, Fig.9, and remove the Upper Blade
Guard Cover.
3. With the cover removed, unscrew the blade securing bolt, with its
washer, completely. Pull off the outer flange, and then the blade.
(Take great care when handling the blade).
You should take this opportunity to clean the inside of the blade guard
of any dust build-up and check generally for security of parts.
NOTE: This machine is capable of accepting blades with bores of 18 and
20mm.
4. Check the bore of your
replacement blade. If it is the
same as the blade you are
replacing, simply mount it on
to the boss of the inner flange
shown in fig. 10, with the
blade tips facing down at the
front. Ensure the parts are
perfectly clean, and the
blade sits snugly on the boss.
5. Replace the outer flange
followed by the securing bolt
with washer - remembering
the bolt has a left hand thread. Leave the bolt finger tight.
6. Replace the upper blade guard cover and securing bolts (F). Tighten
the bolts, but do not overtighten them as this could strip the threads
NOTE:
If you are replacing a 18mm bore blade with an 20mm bore blade, or
vice versa, it will be necessary to pull off the inner flange from the motor
shaft, turn it through 180° and then replace it. The correct boss will now
face outwards allowing you to properly mount the new blade.
7. With the upper blade guard cover secure, tighten the blade securing
bolt using the peg and socket spanners and provided. Do not
overtighten and DO NOT use extensions to the socket spanner lever.
NOTE: The use of HSS blades is NOT recommended.
14
Fig.10