Clarke CMS 200 Instrucciones de uso y mantenimiento - Página 15
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Sander Clarke CMS 200. Clarke CMS 200 18 páginas. 3 in1 multi sander
También para Clarke CMS 200: Manual de instrucciones de uso y mantenimiento (17 páginas)
Imprimir página
ADJUSTMENTS
If you find that the cross cut is not entirely square, it will be necessary to
adjust the head using the 90° adjuster screw shown in Fig. 2 on page 8.
To do this, place a small square on the table. Lower the arm, and bring
the square up to the blade to test for accuracy.
Should any adjustment be required, slacken off the Bevel Locking Nut
and the 90° adjuster screw securing nut, then screw the adjuster
accordingly whilst holding the head firmly against the stop. Tighten the
securing nut when the head is exactly perpendicular.
Similarly should the 45° stop require adjusting, use a 45° template up against
the saw blade to set the adjuster to the correct position.
SPECIFICATIONS
Motor: .................................................. 230V
Running Current ....................... 5Amps
Power Rating: ........................... 800 Watts
Speed: ...................................... 4500RPM
Fuse Rating ........................................... 13Amps
Dimensions: (Head Lowered) ............. 365x345x270mm
Dimensions: (Head Raised) ................ 365x345x410mm
Blade size: (Fitted) ............................... 205mm 40T 18mm Bore
Noise level ........................................... 109.7dB at 1M
Vibration Level ..................................... 22.2m/s² (Normal Load)
Gross weight ....................................... 7.2kg
Part Number ......................................... 6500755
Type of Cut
Cross (90°)
Mitre (at 45°)
Bevel (at 45°)
Compound (at 2x 45°)
Please note that the details and specifications contained herein, are correct at the time of going to
print. However, CLARKE International reserve the right to change specifications at any time without
Maximum Cutting Sizes
prior notice. Always consult the machine's data plate
Depth
50mm
50mm
35mm
35mm
15
50Hz 1 phase.
Thickness
100mm
70mm
100mm
70mm