Clarke CMS 200 운영 및 유지 관리 지침 - 페이지 15

{카테고리_이름} Clarke CMS 200에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CMS 200 18 페이지. 3 in1 multi sander
Clarke CMS 200에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (17 페이지)

페이지 인쇄

ADJUSTMENTS

If you find that the cross cut is not entirely square, it will be necessary to

adjust the head using the 90° adjuster screw shown in Fig. 2 on page 8.

To do this, place a small square on the table. Lower the arm, and bring

the square up to the blade to test for accuracy.

Should any adjustment be required, slacken off the Bevel Locking Nut

and the 90° adjuster screw securing nut, then screw the adjuster

accordingly whilst holding the head firmly against the stop. Tighten the

securing nut when the head is exactly perpendicular.

Similarly should the 45° stop require adjusting, use a 45° template up against

the saw blade to set the adjuster to the correct position.

SPECIFICATIONS

Motor: .................................................. 230V

Running Current ....................... 5Amps

Power Rating: ........................... 800 Watts

Speed: ...................................... 4500RPM

Fuse Rating ........................................... 13Amps

Dimensions: (Head Lowered) ............. 365x345x270mm

Dimensions: (Head Raised) ................ 365x345x410mm

Blade size: (Fitted) ............................... 205mm 40T 18mm Bore

Noise level ........................................... 109.7dB at 1M

Vibration Level ..................................... 22.2m/s² (Normal Load)

Gross weight ....................................... 7.2kg

Part Number ......................................... 6500755

Type of Cut

Cross (90°)

Mitre (at 45°)

Bevel (at 45°)

Compound (at 2x 45°)

Please note that the details and specifications contained herein, are correct at the time of going to

print. However, CLARKE International reserve the right to change specifications at any time without

Maximum Cutting Sizes

prior notice. Always consult the machine's data plate

Depth

50mm

35mm

50Hz 1 phase.

Thickness

100mm

70mm

100mm

70mm