Directed Electronics ProStart CT-5472TW Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Дистанционное пусковое устройство Directed Electronics ProStart CT-5472TW. Directed Electronics ProStart CT-5472TW 19 страниц. Two-way 6-button lcd automatic/manual transmission remote starter system with full alarm system
Печатать страницу
RemoteStarting Your Vehicle
Setting Your Vehicle Into Ready Mode
If your vehicle has a manual transmission you must read the following indications. The unit must
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the
option that was selected by your installer. Therefore, you must follow the appropriate procedure
between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON
(RUN) position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2. With the engine running, apply the parking
brake once and release the brake pedal.
3. Within 20 sec. of engaging the parking
brake, press and hold
the transmitter (SmartStart™ uses only the
SmartStart™ icon).
The parking lights will flash 3 times quickly
and remain lit. Release the button.
4. Remove the key: the engine will keep on running.
5. Exit the vehicle. All doors should be closed, including the hood and trunk.
The engine keeps going until you press either;
•
to lock the doors and shut down the engine;
•
to unlock the doors and shut down the engine;
•
to shut down the engine without affecting the doors.
WARNING: Engine runs until the pre-programmed run time expires.
6. The Parking lights will flash twice and the
mode is set. If the icon doesn't appear, refresh the screen by pressing
Remotestarting
Press the
button for approximately 1 second. The remote will beep once. Approximately
5 seconds later, the remote will play a start melody and the engine will start. The parking lights will
remain ON during the pre-programmed run time of the engine.
If your vehicle does not start at the first attempt, the system will shut down, wait a few seconds and
try to start the engine again. There will be 3 start attempts before the system gives up.
P.6
2. With the engine running, apply the parking
3. Make sure to release the brake pedal.
,
or
on
If Ready Mode is enabled by handbrake
brake twice within 10 sec.
The parking lights will flash 3 times quickly
and remain lit.
icon will appear on screen to indicate Ready
.
User Guide