CLAS OM 8036 Краткое руководство по эксплуатации - Страница 13

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Инструменты CLAS OM 8036. CLAS OM 8036 16 страниц. 2nd generation tool bearing removal 62-85mm

Печатать страницу

OM 8036

2nd GENERATION TOOL BEARING REMOVAL Ø62-85mm

WARNINGS:

This tool set should be used by experienced personnel only

Do not use it with a pneumatic screwdriver

At least the following PPE should be worn when using the tool set

DESCRIPTION

This tool set is a PATENTED and UNIVERSAL solution for removing and refitting modern hubs with integrated bearing

type HBU2 (a pre-assembled unit combining hub and bearing, i.e. the Hub Bearing Unit).

This tool set can be used directly on the car, without having to disassemble the king pin/hub/bearing unit from the

car and placing it on a press.

OPERATION

Both the removal and the insertion steps can be carried out on-board the car.

REMOVAL

During the removal stages, the tool set's modularity consists in its innovative removal semirings

which can be changed by means of intermediate spacers

to be removed.

After releasing wheel, brake caliper, brake disc, drive shaft, etc. (see fig. 2) from the support, remove the bearing, by

assembling the following tool set components as shown in fig. 3:

• 2 removal semirings

• Removal ring, sized according to the bearing diameter

• Thrust bell

;

• Screw M20x1.5

;

• Nut + bearing

;

• Counter-nut

Discharge groove

Hub bearing

as shown in the figure, with spacers

Hbu type hub-bearing to be

replaced like this, already

assembled.

The insertion thrust should take

place in the bearing's outer

groove so as not to compromise

its operation or break it.

(see fig. 3) so as to adapt to the diameter of the bearing

, where applicable;

;

the diameter of