Discount Equipment KL-14 Руководство по эксплуатации - Страница 9
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пила Discount Equipment KL-14. Discount Equipment KL-14 16 страниц. 14” compact saw
Также для Discount Equipment KL-14: Руководство (12 страниц)
Печатать страницу
KL14-I-1017
Disconnect the machine from the power source. Remove the spark plug lead on gasoline engine
models or disconnect the supply voltage connector on electric models, before performing any main-
tenance. All maintenance to be performed regularly by qualified personnel.
•
Never work under saw without first placing chocks on the wheels and support device under the saw to prevent
it from moving or falling. Always work on a flat and level surface.
•
Refer to the engine manual for maintenance information specific to the engine used. Be sure to check oil level
before operation. Clean air filter element daily.
•
Grease bearings after every 4 hours of use. Refer to (page 10) for lubrication points on available models.
•
Perform a visual inspection of the entire machine before operation. Be sure all fasteners are tight and secure,
check for signs of metal cracking or fatigue, inspect for damage to electrical wiring, damage to fuel lines, check
bearings and inspect to be sure proper guards are in place and secure, etc...
•
Inspect belts before operation. Check belt tension. On new equipment, belts should be re-tensioned after the
first four hours of use. Damaged, stretched or excessively worn belts should be replaced with a new matched set.
•
To tension belts, loosen motor mounting hardware slightly. Either push motor towards the rear of the saw
(handle bar side) until the belts are tight or on the models with a belt tensioning adjustment bolt, use bolt to
adjust the engine until the belts are tight. Re-torque the engine mounting hardware.
•
Proper belt tension must be maintained to transmit the engine power to the cutting blade. Slipping belts will
over-heat, the blade life will be shortened and the cutting speed limited. Over tensioned belts will shorten the
belt and bearing life.
•
Check diamond blades for cracks, loose segments and oversize, worn, or out-of-round arbor holes
(See Figure 1) . Do not use any questionable blade since serious injury and/or damage to property can result.
Do not use warped, twisted, or out-of-balance blades. Unbalanced blades will wear excessively, vibrate and
damage both arbor shaft and bearings. Do not use a blade without a drive pinhole (Figure 5) .
For safety reasons, EDCO does not recommend the use of any abrasive blades. Abrasive blades can
•
break and cause serious personal injury to operator and/or bystanders. If abrasive blades are used by choice,
use only reinforced abrasive blades. Inspect abrasive blades carefully.
•
Be sure arbor shaft, backing plate and blade cap are clean and in good
condition. Flanges should be free of nicks and burrs. Replace if out-of-round or worn.
Page 8
Maintenance Instructions
Drive Pin Hole
Figure 9
Figure 5