3D AEROWORKS FUN JET X-88 Руководство по сборке и руководство пользователя - Страница 11

Просмотреть онлайн или скачать pdf Руководство по сборке и руководство пользователя для Игрушка 3D AEROWORKS FUN JET X-88. 3D AEROWORKS FUN JET X-88 18 страниц.

Печатать страницу

3D AEROWORKS FUN JET X-88 Руководство по сборке и руководство пользователя

Insert the torque link and rod through the aileron end of the torque link tube and

secure it to the servo.

Install the servo into the wing, the servo gear needs to be on the same side as the

tube for the torque link (see below). Secure with either hot glue or attach the servo

adaptors and screw into place. (the mount plates in the wing for the servo consist of 4

layers and are quite thick. Pre-drilling with a 1.5mm drill bit is advised before mounting

with either m2 screws or the mount screws that come with the servo.)

Assemble the connector and the torque link using a small screw. NOTE - The torque

link needs to be fitted to the connector so that the screw holds the push rod in the

torque link. See image. (fitting it the other way will allow the rod to fall out of the torque

link)

RDS INSTALLED