3D AEROWORKS FUN JET X-88 조립 설명서 및 사용자 설명서 - 페이지 11

{카테고리_이름} 3D AEROWORKS FUN JET X-88에 대한 조립 설명서 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D AEROWORKS FUN JET X-88 18 페이지.

Insert the torque link and rod through the aileron end of the torque link tube and

secure it to the servo.

Install the servo into the wing, the servo gear needs to be on the same side as the

tube for the torque link (see below). Secure with either hot glue or attach the servo

adaptors and screw into place. (the mount plates in the wing for the servo consist of 4

layers and are quite thick. Pre-drilling with a 1.5mm drill bit is advised before mounting

with either m2 screws or the mount screws that come with the servo.)

Assemble the connector and the torque link using a small screw. NOTE - The torque

link needs to be fitted to the connector so that the screw holds the push rod in the

torque link. See image. (fitting it the other way will allow the rod to fall out of the torque

link)

RDS INSTALLED