3D AEROWORKS FUN JET X-88 조립 설명서 및 사용자 설명서 - 페이지 13

{카테고리_이름} 3D AEROWORKS FUN JET X-88에 대한 조립 설명서 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D AEROWORKS FUN JET X-88 18 페이지.

페이지 인쇄
3D AEROWORKS FUN JET X-88 조립 설명서 및 사용자 설명서
9
Cut two 20mm sections of skewer and fit to the inner section of the wing. Glue the wing to
the fuselage. The carbon or pine main spar should be test fitted before gluing.
10
Glue the sections of the canopy together.
11
Glue the magnets into the canopy and fuselage.
12
Fit the motor to the motor mount and connect to the esc. The motor mount is designed to be
a relatively firm fit. Do not glue it in place, as designed as a pusher it should not fall out
during flight and should be able to be removed for servicing if required.
13
Hot glue or screw the servos to the servo covers and install the aileron servo wires through
the wing into the fuselage.The servo covers can be screwed to the insert of the wing with m2
screws.
Repeat steps 3-9 for the right wing