3D AEROWORKS FUN JET X-88 Посібник з монтажу та інструкція користувача - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник з монтажу та інструкція користувача для Іграшка 3D AEROWORKS FUN JET X-88. 3D AEROWORKS FUN JET X-88 18 сторінок.
Друкувати сторінку
9
Cut two 20mm sections of skewer and fit to the inner section of the wing. Glue the wing to
the fuselage. The carbon or pine main spar should be test fitted before gluing.
10
Glue the sections of the canopy together.
11
Glue the magnets into the canopy and fuselage.
12
Fit the motor to the motor mount and connect to the esc. The motor mount is designed to be
a relatively firm fit. Do not glue it in place, as designed as a pusher it should not fall out
during flight and should be able to be removed for servicing if required.
13
Hot glue or screw the servos to the servo covers and install the aileron servo wires through
the wing into the fuselage.The servo covers can be screwed to the insert of the wing with m2
screws.
Repeat steps 3-9 for the right wing