Dispens-a-Matic Bottle-Matic II Информация и инструкции - Страница 2
Просмотреть онлайн или скачать pdf Информация и инструкции для Упаковочное оборудование Dispens-a-Matic Bottle-Matic II. Dispens-a-Matic Bottle-Matic II 3 страницы. Labeler / applicator
Печатать страницу1. Pull locking assembly "E" forward until it swings freely.
2. With labels facing down, unroll about 2 feet (600 mm.) of the labels and bring them under label drive
roller, which is located in the middle of the machine. Thread the labels between the top and bottom
dispensing tables "A" & "B" and then back towards the label roll. Make sure that the labels are centered
over the micro switch lever located behind the front rubber roller. If needed loosen the thumbscrews on
either side of label roll and slide the roll to the proper position then re-tighten the thumbscrews.
3. Thread the labels under the locking assembly and over rear rubber roller.
4. Put slight tension on the labels by pulling them towards the back of the machine.
5. While keeping tension on the labels pivot the locking assembly "E" towards the back of the machine
until it "clicks" in place over label drive roller. You may need to push hard, but it will "click" when it is
locked.
6. If your machine has the optional "Waste Rewinder" after following previous steps, take the waste
paper back and over the take up spool, put your spring clip on (be sure not to push clip against frame)
7. Simply loosen thumbscrew and slide sensor left/right to desired position, tighten thumbscrew.
8. While thumbscrew is tight, reach under front of machine and grasp sensor housing. Pull housing so
metal lever is away from dispensing table, now carefully push housing towards rear of machine until
lever JUST makes contact with dispensing table. Sensor is now adjusted.
Threading the Labels:
Optional Waste Rewinder
Sensor/Switch Adjustment
Page | 2