3D Systems ProJet 4500 Руководство по постобработке - Страница 11
Просмотреть онлайн или скачать pdf Руководство по постобработке для 3D-принтеры 3D Systems ProJet 4500. 3D Systems ProJet 4500 13 страниц. 3d professional printer
Также для 3D Systems ProJet 4500: Краткое справочное руководство (19 страниц)
Печатать страницу
3 .
Wax contains oils that may separate over long periods of time in the liquid sates . Stir the wax if it has become stagnate . Dip
the part in the wax . Dip only long enough to cover all surfaces; this should take approximately
a .
Be careful as the oven and wax are warm . Use tongs or gloves if necessary .
b.
When melting wax it will appear opaque at first but will become translucent over time.
4 .
Remove excess wax by placing the part back in the oven . Place the part above the open wax container and let any excess
wax drip off into the container . The part will need to be oriented into two (2) or more positions to clear off the bulk of the wax .
Wrapping the part in the paper towel will speed the process .
a.
Parts with small features (cross-sections ≤4mm) must to be kept under
b .
At
50°C
it will take approximately 1 hour for the wax to completely melt off the part .
c.
Large robust parts (all cross-sections ≥ 15mm) can be subjected to temperatures up to
After dipping parts are covered in wax. Keep in oven to let excess wax drip off.
3D Systems, Inc.
Dip part in wax . Use gloves or tongs if necessary .
1 Hour
11
20 seconds
50°C
to prevent distortion .
60°C
to speed the process .
for an entire part .