3DGence DT3 Руководство - Страница 8
Просмотреть онлайн или скачать pdf Руководство для 3D-принтеры 3DGence DT3. 3DGence DT3 14 страниц.
Operation
4.Start the cleaning cycle
To start the machine.
Press the
and the
To stop the machine.
Press the
and the
5. To change the temperature
setting, follow this procedure:
The controller is preset to heat and maintain the
water temperature at 65C (recommended by
3DGence).
To change the temperature press
until is displayed. Then use the
keys to change the temperature. The maximum
temperature is 85C. Press the
to the "home page".
The temperature can be changed while the machi-
ne is running.
IMPORTANT: To immediately power off the 3DGence
DT3 (in case of emergency), turn the power switch
off and unplug the power cord.
(continued)
keys at the same time.
keys at the same time.
and release
or
key to return
3DGence DT3
3DGence DT3
6.Timer (run time) setting
To set the timer to the desired run time, follow this
procedure:
To change the time press and release
until „hour" is displayed.
Then use the
or
time. Press the
key to return to the "home
page".
The time can be changed while the machine
is running.
7. Support Removal
IMPORTANT: Always wear neoprene safety gloves
and eye protection while handling concentrate.
Follow the instructions on the bottle of VXL EX.
Please review the MSDS provided.
(1) Carefully open one 1kg bottle of VXL EX. Slowly
add 1/2 of the bottle into the tank whilethe pump is
recalculating. If solution is not in granular form,
break it up so that it can be added at a consistent
rate. ALWAYS add concentrate to water, NEVER add
water to concentrate.
(2) Wait five minutes (for most of the concentrate
to dissolve).
(3) Place parts directly into the tank or basket.
Jet action cleaning
Jet action cleaning
keys to change the