3DGence DT3 Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} 3DGence DT3. 3DGence DT3 14 pages.

Imprimer la page

Operation

4.Start the cleaning cycle

To start the machine.

Press the

and the

To stop the machine.

Press the

and the

5. To change the temperature

setting, follow this procedure:

The controller is preset to heat and maintain the

water temperature at 65C (recommended by

3DGence).

To change the temperature press

until is displayed. Then use the

keys to change the temperature. The maximum

temperature is 85C. Press the

to the "home page".

The temperature can be changed while the machi-

ne is running.

IMPORTANT: To immediately power off the 3DGence

DT3 (in case of emergency), turn the power switch

off and unplug the power cord.

(continued)

keys at the same time.

and release

key to return

3DGence DT3

6.Timer (run time) setting

To set the timer to the desired run time, follow this

procedure:

To change the time press and release

until „hour" is displayed.

Then use the

time. Press the

key to return to the "home

page".

The time can be changed while the machine

is running.

7. Support Removal

IMPORTANT: Always wear neoprene safety gloves

and eye protection while handling concentrate.

Follow the instructions on the bottle of VXL EX.

Please review the MSDS provided.

(1) Carefully open one 1kg bottle of VXL EX. Slowly

add 1/2 of the bottle into the tank whilethe pump is

recalculating. If solution is not in granular form,

break it up so that it can be added at a consistent

rate. ALWAYS add concentrate to water, NEVER add

water to concentrate.

(2) Wait ﬁve minutes (for most of the concentrate

to dissolve).

(3) Place parts directly into the tank or basket.

Jet action cleaning

keys to change the