3DHobbyShop.com Vyper 46" ARF Руководство по сборке - Страница 10

Просмотреть онлайн или скачать pdf Руководство по сборке для Игрушка 3DHobbyShop.com Vyper 46" ARF. 3DHobbyShop.com Vyper 46" ARF 19 страниц.

Assemble the pushrods for the elevator and ailerons as shown. The longest pushrod in the kit is for the

push-pull rudder and is used in only some applications, which will be mentioned later.

Attach the ball links to the control horns as shown using 2mm screws, washers and nuts. Tighten the

nuts, then apply a drop of CA to each nut to lock it into place so that it cannot come loose. Be sure to

note that the two aileron control horns are different in shape from the elevator horn.

Open the covering over the elevator servo hole and the elevator control horn slot, and install the elevator

servo and pushrod as shown. Glue the control horn into the slot with medium or thick CA glue.

Assemble the pushrod connector onto the servo arm as shown. Note that this pushrod connector must

swivel as the arm moves, so it cannot be tightened down all the way. Just make the nut on the connector

snug, then lock in place with CA glue.