3DHobbyShop.com Vyper 46" ARF 조립 설명서 - 페이지 10

{카테고리_이름} 3DHobbyShop.com Vyper 46" ARF에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DHobbyShop.com Vyper 46" ARF 19 페이지.

3DHobbyShop.com Vyper 46
10
Assemble the pushrods for the elevator and ailerons as shown. The longest pushrod in the kit is for the
push-pull rudder and is used in only some applications, which will be mentioned later.
Attach the ball links to the control horns as shown using 2mm screws, washers and nuts. Tighten the
nuts, then apply a drop of CA to each nut to lock it into place so that it cannot come loose. Be sure to
note that the two aileron control horns are different in shape from the elevator horn.
Open the covering over the elevator servo hole and the elevator control horn slot, and install the elevator
servo and pushrod as shown. Glue the control horn into the slot with medium or thick CA glue.
Assemble the pushrod connector onto the servo arm as shown. Note that this pushrod connector must
swivel as the arm moves, so it cannot be tightened down all the way. Just make the nut on the connector
snug, then lock in place with CA glue.