3DHobbyShop.com Vyper 46" ARF 조립 설명서 - 페이지 12

{카테고리_이름} 3DHobbyShop.com Vyper 46" ARF에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DHobbyShop.com Vyper 46" ARF 19 페이지.

3DHobbyShop.com Vyper 46
12
NOTE – RUDDER SERVO LOCATION
The Vyper can use two types of power systems, lightweight 3S lipo systems and heavier 4S lipo
systems. For the lighter 3S systems, use the pull-pull rudder system with the servo mounted
under the canopy. For heavier 4S systems, use the rear-mount push-pull system with the steel
pushrod. If you are in doubt, we suggest using the pull-pull system.
Both types of installation are detailed below.
PULL-PULL Cable rudder servo installation. (If using the Rear-Mount rudder servo location, please
skip forward to that section)
Remove the covering over the control horn slot in the rudder in the location shown and install the double-
sided pull-pull control horn in the rudder with medium or thick CA glue. Remove the covering over the
slot for the cable to enter the fuselage, as shown.