3DHobbyShop.com Vyper 46" ARF 조립 설명서 - 페이지 14

{카테고리_이름} 3DHobbyShop.com Vyper 46" ARF에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DHobbyShop.com Vyper 46" ARF 19 페이지.

Feed the cables through the slots into the fuselage and route them forwards to the rudder servo location.

They cross over each other to form an X before they reach the rudder servo.

Mount the rudder servo as shown.

Install the rudder servo arm, and spend time to find the exact correct length of the pull-pull wires before

attaching the pull wire ends at the front. The system provides approximately .25 inch of adjustment on

each wire, so your assembly must be accurate. When you are certain your wire length is correct, crimp

the wire to the ends and use the adjustor to properly tension the wires as a final adjustment. We want the

wires to be snug, without sag, but not springy-tight. NOTE – Proper adjustment of the pull-pull wires is

critical. Too-loose wires allow the rudder to flop back and forth in flight, ruining precision flight. Too-tight

wires cause the servo to drag and lose power, leading to a lack of rudder authority. Note that we have

trimmed the pull-pull rudder servo arm to clear the very narrow Vyper fuselage.