Alto 30HA STANDARD I/MASTER I Руководство по эксплуатации - Страница 15
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Мойка высокого давления Alto 30HA STANDARD I/MASTER I. Alto 30HA STANDARD I/MASTER I 19 страниц. Alto-shaam inc. pressure washer user manual
Также для Alto 30HA STANDARD I/MASTER I: Руководство пользователя (19 страниц)
4.5 Working methods
Your high pressure washer has been developed for cleaning according to the so-called „2-step method".
STEP 1
STEP 2
In practice the working process is laid down in accordance with the actual job, but as a starting point the
following working method can be described for a job:
1. Apply detergent under low pressure. The dosage is chosen according to the job, which is to be
carried out, and the adjustment is made on the dosing unit.
2. Await acting time. Let the detergent act on the dirt/surface for a short time prior to pressure cleaning
- usually a few minutes.
3. High pressure cleaning. Clean all surfaces under high pressure.
4. Rinse afterwards, if necessary. To make sure that residual impurities are removed from the surface.
In connection with the working process the optimum cleaning will be reached by following these 3 pieces of
advice:
Advice no. 1
When using a detergent, always apply it on a dry surface. If the surface is rinsed with water at first, it may
be difficult for it to absorb the detergent, and the result is a reduced effect of the detergent.
Advice no. 2
When applying a detergent on large vertical surfaces (i.e. the sides of a truck) work from below and up-
wards. Thus you will avoid detergent running off the surface through grooves and dark streaks appearing
on the surface whilst cleaning.
Advice no. 3
During the high pressure cleaning you should work so that the high pressure water does not run over the
surface which has not been cleaned yet. This is to ensure that there is sufficient detergent on the surface
when the high pressure water hits the surface.
5.0 Disposable waste
This high pressure washer consists of parts which can damage the invironment when thrown away. Parts
that can polute are as follows:
Oil, painted/zinck-coated parts, plastics/plastic-coated parts.
Therefore, it is important to follow the laws concerning the removal of poluting and dangerous materials
when replacing spare parts or disposing of high pressure washer. It is recommended that you bring the
rejected parts to waste disposal areas or recycling plants that are approved by the state for the destruction
of these types of materials.
Fields of application and working methods
Application of detergent
High pressure cleaning
GB
13