3Doodler Create+ Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Аксессуары 3Doodler Create+. 3Doodler Create+ 11 страниц.
Также для 3Doodler Create+: Руководство пользователя (16 страниц)
Печатать страницу
1.
My pen won't
turn on (the LED
light isn't on)
2.
Plastic won't stick
to the paper, or is
curling up around
the nozzle
3.
Plastic is not
extruding from my
3Doodler Create+
02/2022
Let's double check the following:
1A. Is the end of the power
adapter connected to the
correct part of the pen?
NOTE:
If you have a spare power adapter please use it to test your 3Doodler Create+. You will need
a DC 5V2A power supply with a 3.5mm barrel. This will help determine if the problem is with
your 3D pen or with the included power adapter.
Stop extruding and start again using the following
instructions:
When the plastic resumes extruding, push the nozzle firmly
down into the paper, allowing the plastic to stick to the paper.
Drag the plastic along the paper or surface in a continuous
unbroken line as if you were writing with a pencil.
Keep your movement slow and steady. The plastic should hold
to the paper and not curl up around the nozzle.
3A.
The plastic is not engaging properly with the drive gear:
With the pen in drive, gently push on the filament strand until you
feel it being pulled through the drive gear on its own.
If the above does not work, reverse the plastic from the pen.
Section
4) Snip the ends, put the pen in drive, reinsert the filament,
and try again. If the plastic is too short to be reversed from the
back of the pen, move to 3B.
3B.
The plastic is too short to be removed from the pen:
Mini
Spanner
While the pen is on and the nozzle is hot,
unscrew the nozzle using the mini spanner.
1B. Is the power adapter
plugged into a working
power outlet?
BLUE
or
GREEN
Light
Double click either speed button to
set the pen into reverse. Insert the
unblocking tool through the front end
of the pen and gently push any excess
plastic out through the back of the pen.
SECTION 3: TROUBLESHOOTING
1C. Make sure the control
switch on your 3Doodler
Create+ is not in the OFF
position.
(See
Unblocking Tool
6
EN