esera automation auto connect 11324 Руководство пользователя
Просмотреть онлайн или скачать pdf Руководство пользователя для Шлюз esera automation auto connect 11324. esera automation auto connect 11324 8 страниц. 1-wire gateway 10 modbus rtu
Печатать страницу
Art. No. 11324
1-Wire Gateway for autonomous communication between
PLC and a 1-Wire sensor and actuator network
Fast readout of all 1-Wire devices in the
1-2 seconds clock
Data output via Modbus RTU (RS485) Protocol
Processed sensor and actuator data
Status of each sensor and actuator can be called up
Convenient configuration program
No additional drivers necessary
Optional data storage in case of interruption of
communication to the control system / host system
Power supply for 1-Wire network
Designed for all 1-Wire network sizes
DIN rail enclosure for switchboard assembly
Wide supply voltage range
Management of all ESERA automation and many
Standard 1-Wire sensors and actuators
1
Introduction
Before you begin with the installation of the 1-Wire Gateway 10 Modbus and put the device into operation,
please read these operating instructions carefully until the end, especially the section on safety instructions.
All settings and configurations of the 1-Wire Gateway are carried out with the ESERA Config Tool 3. You can
find this software on the ESERA website. Please observe the operating instructions for the
ESERA Config Tool 3, which can be found within the Config Tool 3 software under the "HELP/SUPPORT"
tab.
2
Product description
Standard Modbus RTU Protocol
You can communicate with your industrial controller, e.g. PLC, via standard Modbus RTU protocol with the 1-
Wire Gateway 10. The addressing is clearly structured, comparable to many other Modbus systems.
Addresses for system, sensor and actuator data are available.
We provide an address overview with all available data points via the download area of the article on our
website and via the ESERA Config Tool 3 configuration software.
3
Auto-E-Connect® Support
The ESERA Auto-E-Connect® 1-Wire Plug and Play system will be used for the
1-Wire Bus supported. This enables fully automatic configurations of 1-Wire sensors
and actuators on the 1-Wire bus. It is optimized for industrial applications and
enables significant added value beyond the sensor and chip data.
The Auto-E-Connect function automatically recognizes ESERA chips, sensors and actuators, starts suitable
libraries and outputs fully formatted data.
The Auto-E-Connect functionality will be available from mid 2020 via 1-Wire Controllers, 1-Wire Gateways and
1-Wire ECO from ESERA available.
Further information on ESERA Auto-E-Connect can be found on the ESERA website, ESERA Config-Tool 3, or in
the download area for this article in the ESERA Webshop.
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH, ESERA-Automation 2020
www.esera.de
User Guide
1-Wire Gateway 10 Modbus RTU
11324 V2.0 R1.0 Manual
Page 1 of 8