Dixon Bayco FloTech FT208 Руководство - Страница 14

Просмотреть онлайн или скачать pdf Руководство для Монитор Dixon Bayco FloTech FT208. Dixon Bayco FloTech FT208 20 страниц. Checkmate programmable retain / overfill onboard monitor

Печатать страницу

1. Troubleshooting

A PERMIT signal will be issued if:

 All the sensor inputs that have been programmed as active see dry sensor signals.

 Any of the Retain sensors are wet and the Retain Reset pushbutton has been pressed.

 All the sensor inputs that have been programmed as inactive see no signals.

 The AUX input is jumpered or made through an external set of contacts.

A PERMIT signal will NOT be issued if:

 Any of the sensors that have been programmed as active are wet or are not connected.

 Any of the sensors that have been programmed as inactive see a sensor signal.

 The AUX input is not jumpered or made through an external set of contacts.

Retain Sensor Override

Should a driver wish to load over retained product, such as splash blending, the driver must do the following:

1. Connect the API plug from the rack to the optic or thermistor socket on the trailer. The monitor will be

in a non-permissive state (Green Permit led will be off).

2. Press the Retain Reset switch. The monitor is now in a permissive state (Green Permit led will be on)

and a permit load signal will be sent to the loading rack.

3. The monitor will remain in a permissive state until the API plug is removed from the trailer socket.

Then the monitor will switch to a non-permissive state and prevent future loading until the API plug is

again connected to a rack.

FloTech Programmable CheckMate Retain / Overfill Monitor

10466 REV N

FT208 CheckMate