ClearView RT-RT110 Руководство по установке - Страница 13

Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильные аксессуары ClearView RT-RT110. ClearView RT-RT110 20 страниц.

Assembly Instructions

10. Use a sharp utility knife to cut through MUDFLAP using the groove and a straight

edge as a guide. This may take several passes to completely cut through MUDFLAP.

Refer Image 8. Repeat procedure for 2nd MUDFLAP.

IMPORTANT: Place a scrap piece of wood under the MUD FLAPS when punching or

drilling holes, as the punch will dull and may damage the surface underneath.

11. Punch the top row of pre-

moulded holes in the MUDFLAP

using the included BOLT HOLE

PUNCH.

Refer Image 9.

12. Assemble the cut end of the MUDFLAP into FLAP CLAMP by either sliding or pushing it

down onto the top of the MUDFLAP with the square holes on the smooth side.

Note: Should it be difficult to slide MUDFLAP into FLAP CLAMP, lubricate the cut end of

the MUDFLAP surface before inserting - i.e. a dry lubricant, such as WD40 Dry PTFE

Lubricant may be used to help with Installation.

Insert the five M8 FLAP CLAMP BOLTS through the square holes. Loosely attach the

M8 FLAT WASHER and M8 NYLON INSERT HEX NUT to the back as shown. (Do not

tighten yet.) Refer Image 10. Repeat for 2nd MUDFLAP.

13. Slide the FLAP CLAMP with the attached MUDFLAP over the FLAP SUPPORT ROD with

the NYLON INSERT HEX NUTS facing your vehicle. Position the MUDFLAPS and FLAP

SUPPORT RODS (left and right) as desired for your vehicle. Line up a small hole in FLAP

CLAMP with one of the three flap adjustment holes in SUPPORT ROD depending on

vehicle size.

Inner Hole - for small and mid-sized vehicles

Center Hole - for full-size vehicles

Outer Hole - for large vehicles, such as dually trucks and small motor homes

Finally, insert the small M5 FLAP RETAINER BOLT through the FLAP CLAMP and

SUPPORT ROD and attach the M5 NYLON INSERT HEX NUT.

Refer Images 1 & 6. Repeat for 2nd MUDFLAP.

Bolt Hole Puch

Pre-Molded Holes

Wood Block

under Mudflap

clearviewaccessories.com.au

IMAGE 9

Cut Edge