Clearwater Spas CLEAR Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Система водоснабжения Clearwater Spas CLEAR. Clearwater Spas CLEAR 8 страниц.
1.
Fill your hot tub with water to the appropriate level (check your spa
manual for reference).
2.
Test the alkalinity, pH, and calcium levels using the test strips provided.
Adjust the water if necessary using the appropriate products.
3.
If the TA (total alkalinity) and pH both need adjusting, correct the TA
first. Reference the test strip to determine the levels. Your water should
read as follows:
pH: 7.2-7.6 (too low and the copper cell will erode; too high and
copper will precipitate on the spa's surface)
TA: 80-120 ppm
CH: 150-300 ppm
4.
Setting the copper level: Press the button. It's as simple as that. If you
need to bring the copper level up press the CLEAR button to give it a
boost in copper/silver ionization. It will take approximately 2 days to
attain the minimum copper residual of 0.2ppm and 5 days to attain the
copper residual of 0.4ppm.
5.
Bacteria Test: Once the copper has reached optimum level, you
may test water for bacteria by following the directions on the
bacteria test kit provided. Use the bacteria test strips and repeat
as needed. IMPORTANT! CLEAR IS DESIGNED TO WORK IN
CONJUCTION WITH LOW LEVELS OF CHLORINE. A minimum of
0.6 to 5 ppm is recommended. Check the sanitization levels regularly.
IMPORTANT! Do not use bromine or chlorine tablets.
If your spa tests positive for bacteria, immediately super-chlorinate
minimum 10ppm) your spa using spa chlorine only and do not use for 8
hours.
GETTING STARTED
CLEAR | State of the Art Water Management | 5