Clearwater Spas CLEAR Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Система водопостачання Clearwater Spas CLEAR. Clearwater Spas CLEAR 8 сторінок.

Fill your hot tub with water to the appropriate level (check your spa

manual for reference).

Test the alkalinity, pH, and calcium levels using the test strips provided.

Adjust the water if necessary using the appropriate products.

If the TA (total alkalinity) and pH both need adjusting, correct the TA

first. Reference the test strip to determine the levels. Your water should

read as follows:

pH: 7.2-7.6 (too low and the copper cell will erode; too high and

copper will precipitate on the spa's surface)

TA: 80-120 ppm

CH: 150-300 ppm

Setting the copper level: Press the button. It's as simple as that. If you

need to bring the copper level up press the CLEAR button to give it a

boost in copper/silver ionization. It will take approximately 2 days to

attain the minimum copper residual of 0.2ppm and 5 days to attain the

copper residual of 0.4ppm.

Bacteria Test: Once the copper has reached optimum level, you

may test water for bacteria by following the directions on the

bacteria test kit provided. Use the bacteria test strips and repeat

as needed. IMPORTANT! CLEAR IS DESIGNED TO WORK IN

CONJUCTION WITH LOW LEVELS OF CHLORINE. A minimum of

0.6 to 5 ppm is recommended. Check the sanitization levels regularly.

IMPORTANT! Do not use bromine or chlorine tablets.

If your spa tests positive for bacteria, immediately super-chlorinate

minimum 10ppm) your spa using spa chlorine only and do not use for 8

hours.

GETTING STARTED

CLEAR | State of the Art Water Management | 5