Edic ENDEAVOR Руководство пользователя/оператора - Страница 10

Просмотреть онлайн или скачать pdf Руководство пользователя/оператора для Ультразвуковой очиститель ювелирных изделий Edic ENDEAVOR. Edic ENDEAVOR 17 страниц. Multi-purpose extractor
Также для Edic ENDEAVOR: Краткие руководства (15 страниц)

Печатать страницу

UTILIZING AUTO-FILL & AUTO-DUMP:

This machine is equipped with the ability to self-regulate

the levels of fluid in the solution tank and the recovery

tank.

Auto-Fill:

1. Connect a 3/4" garden hose to a faucet.

2. Connect opposite end of the garden hose to the

female garden hose connection located on the rear

bottom left of the machine. See #11 on page 6.

3. Turn the water pressure on to about 1/4 to 1/2 of the

full flow. Do not turn to full pressure.

4. Wait for the solution tank to fill and confirm it has

stopped filling before walking away to begin your

job.

5. The Auto-fill function is controlled by a float valve.

Any obstruction of the float valve could lead to

flooding or not filling at all. Check that the float is

moving freely before and after every job.

Auto-Dump

1. Remove the cap from the male garden hose connec-

tion on the rear bottom left of the machine. #10 on

page 6.

2. Connect a 3/4" garden hose to the male garden hose

connection. #10 on page 6.

3. Secure the opposite end of the garden hose to an

approved drain or sewer system. Secure end of hose

to prevent flooding.

4. When ready to start recovering water, turn on the

PUMPOUT switch. #9 on page 5.

5. The pump can be left on throughout your job so long

as small amounts of water are flowing through the

pump. Turn off the PUMPOUT switch if you will not

be recovering water for periods lasting longer than 2

minutes.

6. Clean your Auto-Dump filter and vacuum filter

bag after every job. Some jobs, such as carpet may

require multiple cleanings of the filter during opera-

tion.

NOTE: Periodically stop to monitor your solution tank

and recovery tank levels to ensure that the Auto-Dump

and Auto-Fill features are working properly. This could

prevent flooding.

PRIMING THE PUMP:

THE ENDEAVOR HAS A PISTON PUMP WHICH IS

NOT SELF-PRIMING. PRIMING RESTORES PRES-

SURE TO THE PUMP WHEN AIR HAS BEEN INTRO-

DUCED INTO THE PUMP SYSTEM.

WARNING: TO PREVENT FLOODING, NEVER

LEAVE THE MACHINE UNATTENDED WHILE

THE PRIMING VALVE IS IN THE OPEN POSITION.

1. Place water in the solution tank by using the Auto-Fill

feature or by using a bucket or hose to fill from the

solution tank access point (see #5 on page 6)

2. Open the pump line by turning the priming valve a

VAC

PUMP

1/4 turn counter-clockwise toward the letter "P". (See

#9 on page 7)

PUMPOUT

3. Place the pump switch into the on position. Position

"l" (see #2 on page 7)

4. Allow the pump to run for 15-20 seconds.

VAC

PUMP

5. Close the priming valve and return it to its original

position.

PUMPOUT

6. Once the priming valve has been closed, the gauge

will display the current pressure. Use the regulator to

adjust pressure, if necessary. See next section to adjust

pressure.

7. Repeat steps 1-5 if pressure on gauge is still showing

less than desired pressure.

HEATER