Edic ENDEAVOR Руководство пользователя/оператора - Страница 11

Просмотреть онлайн или скачать pdf Руководство пользователя/оператора для Ультразвуковой очиститель ювелирных изделий Edic ENDEAVOR. Edic ENDEAVOR 17 страниц. Multi-purpose extractor
Также для Edic ENDEAVOR: Краткие руководства (15 страниц)

Печатать страницу

ADJUSTING PUMP PRESSURE:

This machine is equipped with a pressure regulator (see

#5 on page 7), that allows the operator to adjust the pres-

sure between 100PSI and 500PSI.

To adjust pressure:

1. Turn Pump switch to on position. Position "l".

2. Check current pressure on pressure gauge. (#4 on

page 7)

3. To increase pressure, turn the regulator in a

clockwise motion. Watch the gauge and stop

rotating the regulator when the desired pres-

sure has been reached. Max pressure is 500PSI.

4. To decrease pressure, turn the regulator in a count-

er-clockwise motion. Watch the gauge and stop

rotating the regulator when the desired pressure

has been reached. Minimum pressure is 100PSI.

Note: Do not adjust the pressure while spraying.

Adjusting the pressure, while spraying, will cause the

pump to over-pressurize and place excess load on the

pump motor. Do not exceed 500PSI. Take care when

reducing the pressure below 100PSI as the regulator

adjuster nut may come off the threaded regulator

shaft.

HOW TO SETUP THE ENDEAVOR FOR

CLEANING CARPET OR UPHOLSTERY:

1. Plug in power cords as per instructions on page 8.

2. Make sure you are on 2 circuits.

3. Connect your solution and vacuum hoses to ma-

chine and accessories.

4. Fill the machine with water. See page 10 for auto fill

instructions.

5. Prime the pump as per instructions on page 10.

6. Adjust the pressure to desired pressure between 100-

500psi. See instructions for adjusting pressure on

page 11.

7. Prespray the carpet or fabric as necessary.

8. Turn on the vacuum motor.

9. Spray on the backstroke and do a dry stroke when

pushing forward.

10. Overlap your previous path slightly when you pull

back.

11. Monitor the levels in the recovery tank and empty

as necessary. Use defoamer to ensure your vacuum

motor does not take in fluid