djm direct DJMBD13-40 Оригинальное руководство по эксплуатации - Страница 13
Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для Сверло djm direct DJMBD13-40. djm direct DJMBD13-40 19 страниц. Bench drill
Печатать страницу12. Storage
Danger! Store the drill press a way it
cannot be started by unauthorised
persons and that nobody can be injured.
Caution! Do not store the drill press
unprotected outdoors or in a moist
environment.
Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from
dust and moisture.
Store the operating manual with the electrical tool.
Problem
1.
tripped.
Device doesn't start.
2. On switch (green) / Off. Switch (red) (1) is
broken.
3. Motor faulty.
No Motor
1. Motor not fixed in place.
output turns off
2. Bit not centrally clamped.
automatically
Loud squeaking noise. 1. Incorrect belt tension
2. Dry spindle
3. Loosed spindle pulley
4. Loosed motor pulley
The drill bit burns or
1. Drilling at the incorrect speed 2. The wood
smokes
chips are not
coming out of the hole
3. Dull drill bit
4. Feeding the workpiece too slowly
5. Not lubricated
Excessive drill run out
1. Bent drill bit
or wobble;drilled hole
2. Bit improperly installed in the chuck
is not round
3. Worn spindle bearings
4. Lengths of cutting flutes or angles not
appropriate for the hardness of the wood grain
5. Chuck not properly installed
Drill bit binds in the
1. The workpiece is pinching the bit 2. Excessive
workpiece
feed pressure
Spindle returns too
Coil spring has improper tension
slowly or too quickly
Trouble Shooting
Cause
No mains voltage.Main circuit breaker is
1. Check the socket, mains supply cable, cord,
mains plug; if necessary, have them repaired
the main fuse.
2. Repair by Customer Care.
3. Repair by Customer Care.
1. Check the tension of the V-belts and tighten
the clamping screw.
2. Check the bit in the drill chuck.
1. Adjust the belt tension
2. Lubricate the spindle
3. Tighten the retaining nut on the pulley insert
4. Tighten the set screw on the side of the
motor pulley
1. Change the speed
2. Retract the drill bit frequently to clear the
chips
3. Resharpen or replace the drill bit 4. Feed fast
enough to cut the
workpiece
5. Lubricate the drill bit with cutting oil
1. Replace the drill bit
2. Reinstall the bit.
3. Replace the bearing. Take the press to a
qualified service technician
4. Resharpen the drill bit correctly or replace
with the appropriate type.
5. Reinstall the chuck.
1. Support or clamp the workpiece. 2. Feed
more slowly.
Adjust the coil spring tension
12
Remedy