djm direct DJMBD13-40 Оригинальное руководство по эксплуатации - Страница 11
Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для Сверло djm direct DJMBD13-40. djm direct DJMBD13-40 19 страниц. Bench drill
Печатать страницу5. You can also adjust the tilt angle of the drilling
bench. To do this, release the retaining screw under
the drilling bench with an open end wrench SW 19 (not
scope of delivery). Tilt the drilling bench as desired
to the right or left up to a max. of 45° and secure the
drilling bench again with the retaining screw.
Changing the Drill Bit
Remove the plug from the mains socket before
changing the bit. This will prevent an accidental start-
up.
1. Fold the drill chuck guard up.
2. Release the retaining jaws of the drill chuck with
the drill chuck key .
3. Remove the bit.
4. Insert a new bit.
5. Tighten the retaining jaws of the drill chuck with
the drill chuck key.
6. Check that the bit is centred.
7. Fold the drill chuck guard down again.
8. Attach the drill chunk key back to the key holder.
Under no circumstances must you
leave the drill chuck key inserted.
9. Operation
Always place a piece of backup material
(wood, plywood, etc.) on the table
underneath the workpiece. This will
prevent splintering on the underside
of the workpiece as the drill bit breaks
through. To keep the material from
spinning out of control, it must contact
the left side of the column, or be
clamped (not included) to the table.
For small workpieces that cannot be
clamped to the table, use a drill press
vise (not included). The vise must be
clamped or bolted to the table to avoid
injury.
Drilling
1. Starting the drill press.
• The drill press can be switched on by pressing
the green On switch ''I''.
• The red Off switch ''0'' has to be pressed to switch
off the drill press.
2. Turn one of the drill lifting arms anticlockwise. 3.
The drill chuck is lowered.
4. Drill into the workpiece at the appropriate feed rate
and to the desired depth.
5. Be aware of any necessary chip breaking on the
way to the desired depth.
6. Move the bit slowly back to the stop position.
General Drilling Guidelines - Drilling A Hole
WARNING: To prevent the workpiece and
the backup material from slipping from
your hand while drilling, position the
workpiece and backup material to the left
side of the column. If the workpiece and
the backup material are not long enough
to reach the column, clamp the workpiece
and backup material to the table. Failure
to do this could result in personal injury.
1. Mark where you want to drill the workpiece by
using a center punch or a sharp nail.
2. Before turning the drill press ON, turn the drilling
lifting arms to bring the drill bit down. Line the drill bit
tip up with the mark. Clamp the workpiece in place.
3. Turn ON the drill press and pull down on the drilling
lifting arms with the appropriate force needed to allow
the drill bit to drill the material.
10