Alvarado CSG Руководство по установке и обслуживанию - Страница 7

Просмотреть онлайн или скачать pdf Руководство по установке и обслуживанию для Ограждения и ворота Alvarado CSG. Alvarado CSG 10 страниц. Bi-directional waist high security gate

Печатать страницу

CSG/SSG/CFG Installation and Maintenance Instructions

Installing the Protective Pads (CFG Only)

Use the supplied protective pads to dampen metal on

metal noise, and minimize wear and tear to the crash plate.

17. Using a mild soap and water solution, clean the crash

plate surface of any dirt, oil or debris. Be sure to

thoroughly wipe dry the surface after cleaning.

18. Peel the backing off a protective pad and apply it to

the desired location on the crash plate using even

pressure [Figure 9].

19. Repeat steps 1 and 2 using the other protective pad

and the other side of the crash plate.

Both pads can applied to the entry

NOTE

side of the crash plate for left- or right-

swing configurations.

Functions Check

1. Walk through the gate. The gate should move smoothly and return to the closed position.

2. Verify the hinge post and gate arm are horizontally and vertically level.

3. Ensure the gate arm and hinge post form a 90° angle.

Cleaning and Maintenance

Setting up a cleaning and maintenance schedule along with proper maintenance will ensure maximum performance

and long service life of the gate. In addition, proper cleaning is required to achieve maximum corrosion resistance and

aesthetic appeal.

Exterior Cleaning

The frequency of exterior cleaning will depend on the environment in which the gate is installed. Alvarado

recommends cleaning every (60) days for gates installed indoors or in temperate climates. If a stainless steel gate

(SSG) is installed outdoors, clean the gate on a more frequent basis. A best practice for preventing build-up of

contaminants is to wipe down the gate with a damp cloth on a daily basis. Due to the different types of exterior

finishes available, different types of care must be taken to keep the gate looking clean.

•

Stainless Steel - Regular cleaning is the best way to maintain any stainless steel finish. Regular cleaning can

be accomplished by wiping down the gate with a damp cloth. For stubborn stains and heavy spotting, our #1

recommendation is MAAS Metal Polish (in the liquid form). Follow the manufacturer's directions, but in brief: (1)

wipe down excess dirt from the gate, (2) apply polish to the metal, (3) polish in the direction of the grain with a

super fine (0000) or fine (000) synthetic steel wool (never use standard steel wool), (4) wipe clean, (5) repeat

steps 2 - 4 until clean.

•

Chrome - Periodic cleaning with a mild glass or all-purpose cleaner is the best way to prevent build-up of

contaminants on chrome surfaces. For stubborn stains, heavy spotting and rust, our #1 recommendation is MAAS

Metal Polish (in the liquid form). Follow the manufacturer's directions. Do not install chrome gates (CSG/CFG)

outside.

•

Powder Coat Finishes – To clean the powder coat finish, use a neutral detergent, such as a car shampoo, and

rinse with clean water. In the event that the powder coat finish is chipped, and bare metal is showing, seal the

area as soon as possible. If the area is not sealed, the underlying metal will rust, which could eat away the

powder coat and cause flaking.

Created on: 10/7/2013

For Assistance: [email protected] (909) 591-8431

Fig. 9

CFG Protective Pads

Protective Pad

Crash

Plate

Page 7

PUD3570R2-0