FLENDER FASTEX EC210 Руководство по сборке и эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Руководство по сборке и эксплуатации для Промышленное оборудование FLENDER FASTEX EC210. FLENDER FASTEX EC210 17 страниц.
Печатать страницу4.1 Assembling the clamping element
The design torque T
ensured that the cylinder head bolts are tightened with the tightening torques
according to Table 7-1
Preparatory work
1. Make sure the surfaces to be joined are in perfect condition.
2. Reused clamping sets must be disassembled and cleaned before being used again. The
3. Clean the contact surfaces as well as the shaft and hub.
4. The contact surface between shaft (4) and hub/hollow shaft (5) must not be oiled or
5. Place the outer ring (2) on the inner ring (1).
6. Screw the outer ring (2) and the inner ring (1) together without tightening the hexagon
Assemble
1. Position the preassembled clamping element on the hollow shaft/hub (5) and then guide
2. Tighten the hexagon head screws (3) slightly so that the clamping element can still be
3. Align the clamping element on the shaft (4).
4. The shaft must fill the entire length of the clamping set.
5. Tighten the hexagon head screws (3) one after the other in several turns until the inner
FASTEX EC210 Clamping element 3910de
Compact assembly and operating instructions 05/2022
WARNING
must not be exceeded at any operating point. It must be
C l
conical surfaces and threads must be greased with Molykote MoS2. When using
Geomet-coated hexagonal screws (3), the threads and the hexagonal screws (3) must
not be greased with Molykote MoS2.
greased. The contact surface between the clamping set and the hub/hollow shaft may be
greased.
head screws (3).
both parts onto the shaft (4).
moved.
ring (1) is aligned with the outer ring (2). The prescribed tightening torque can be found
in the section Tightening torques and wrench sizes.
10