FLENDER FASTEX EC210 Montaj ve Kullanım Talimatları Kılavuzu - Sayfa 10

Endüstriyel Ekipmanlar FLENDER FASTEX EC210 için çevrimiçi göz atın veya pdf Montaj ve Kullanım Talimatları Kılavuzu indirin. FLENDER FASTEX EC210 17 sayfaları.

Sayfayı Yazdır

4.1 Assembling the clamping element

The design torque T

ensured that the cylinder head bolts are tightened with the tightening torques

according to Table 7-1

Preparatory work

1. Make sure the surfaces to be joined are in perfect condition.

2. Reused clamping sets must be disassembled and cleaned before being used again. The

3. Clean the contact surfaces as well as the shaft and hub.

4. The contact surface between shaft (4) and hub/hollow shaft (5) must not be oiled or

5. Place the outer ring (2) on the inner ring (1).

6. Screw the outer ring (2) and the inner ring (1) together without tightening the hexagon

Assemble

1. Position the preassembled clamping element on the hollow shaft/hub (5) and then guide

2. Tighten the hexagon head screws (3) slightly so that the clamping element can still be

3. Align the clamping element on the shaft (4).

4. The shaft must fill the entire length of the clamping set.

5. Tighten the hexagon head screws (3) one after the other in several turns until the inner

FASTEX EC210 Clamping element 3910de

Compact assembly and operating instructions 05/2022

WARNING

must not be exceeded at any operating point. It must be

C l

conical surfaces and threads must be greased with Molykote MoS2. When using

Geomet-coated hexagonal screws (3), the threads and the hexagonal screws (3) must

not be greased with Molykote MoS2.

greased. The contact surface between the clamping set and the hub/hollow shaft may be

greased.

head screws (3).

both parts onto the shaft (4).

moved.

ring (1) is aligned with the outer ring (2). The prescribed tightening torque can be found

in the section Tightening torques and wrench sizes.