Ashford KIWI 3 SPINNING WHEEL Руководство по эксплуатации - Страница 9
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Инструменты и аксессуары для ткачества Ashford KIWI 3 SPINNING WHEEL. Ashford KIWI 3 SPINNING WHEEL 14 страниц.
Печатать страницу
Align the groove in the
wheel with the hole in
crank. Locate the
hub pin into the
groove and tap
partially into the
hole in the crank.
Place the indented
end of a lazy kate
pin over the hub
pin and carefully
tap until level with
the wheel.
Lay the wheel on it's
back. (protect your table
with a towel or piece of
cardboard)
Insert the front conrod
joint into the right
treadle board.
Then repeat this
sequence for the rear
conrod and the left
treadle board.
NOTE: It easier to insert the rear
conrod joint into the treadle
board when the treadle board
is at the lowest point - turn the
wheel until the rear conrod is in
the lowest position.
Hold the conrod joint
with one hand on either
side of the treadle board.
The lazy kate pins
have an indent on
one end.
Rear
With both hands turn
the conrod joint a ¼ turn
towards you.
Slide it up into the small
slot and turn it back a ¼
turn until it clicks into place.
9
Note that
the rear
conrod
attaches
to the left
treadle
board and
the front
conrod
attaches
to the right
treadle
board.