Ashly FR-16 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Пульт дистанционного управления Ashly FR-16. Ashly FR-16 12 страниц. Fr remotes network remote controls
Также для Ashly FR-16: Руководство по эксплуатации (17 страниц), Спецификация продукта (2 страниц)
Operating Manual - FR-8 and FR-16 Remote Level Controller
Switch Button LED Function:
enable (green) for each fader, but can be alternately set to indicate signal level. When set for signal
level mode, the LEDs use green and amber to indicate the post-fader signal level in dBu at the point
of gain control for each fader. Every fader's LED transition points can be individually set.
LED Brightness:
of four levels to match ambient room lighting. The factory default is for the brightest setting.
Clear All:
window and returns them to factory default settings. It also clears the FR device target security user
name and password. Note: individual fader parameters can be cleared by clicking on any control for
that fader and then clicking the pop-up "Clear Fader" button associated with that fader.
Fader Control Features:
ment of the targeted device, fader mode, device channel, mixer sub-channel (if in mixer mode), fader
scaling, signal LED breakpoints (if the switch button LEDs are selected for signal level mode), and
assign to master fader. An individual fader clear function button appears when editing any control
point in a fader row. This returns that fader's parameters back to default settings.
Fader:
The total number of faders available on the FR remote are shown here, either 8 or 16.
Device:
Each fader can be programmed to control one exclusive NE device available in the
drop down menu, or to be inactive.
Mode:
Once a target DSP device has been selected, the fader can operate in one of two
modes, Mixer Mode or I/O Level Control Mode.
Mixer Mode - In mixer mode, the fader is first assigned to the target device's output
channel mixer, then assigned to a mixer sub channel, whereby the fader acts as a level control corre-
sponding directly to one of that mixer's input sources. The mixer sub channel feature is only avail-
able in mixer mode.
I/O Level Control Mode - I/O level control mode offers individual assignment of
faders to single input or output channel DSP gain controls on the targeted device, whereby the fader
works along with the DSP gain function. For controlling a stereo signal, one FR fader can control
more than one device channel by linking input or output gain functions within the target device.
Fader Scaling
the FR fader will use the full range of the DSP gain function under its control. An upper or lower
fader limit can be assigned to prevent insufficient or excessive audio level.
LED Level Transition Points -
mode, the two thresholds at which point the green signal LED first turns on and then transitions from
green to amber can be defined by the user. Factory default transition points are -22dBu for green and
+14dBu for amber.
Master Fader Assignment
control by the master fader. The factory default is for all faders to be assigned to the master fader. If a
fader appears to be functioning but has no effect on level, check that the master fader is not muted or down.
6
The overall brightness of FR-8 and FR-16 LEDs can be adjusted to one
This button clears the control parameters of all faders in the configuration
- The gain range for target DSP gain stages is -50dB to +12dB. By default,
- Faders can be individually selected for or removed from
All switch LEDs normally indicate mute (red) or
Individual fader control parameters include assign-
When the switch button LEDs are set to signal level