AMC XP1000se Manuel - Sayfa 7

Amplifikatör AMC XP1000se için çevrimiçi göz atın veya pdf Manuel indirin. AMC XP1000se 16 sayfaları. Stereo preamplifier

Sayfayı Yazdır

INPUTS

All audio Inputs are via RCA type RCA

connectors. All the RCA sockets on

your AMC amplifier are marked "L" for

left and "R" for right channels, with the

left channels nearer the top of the

cabinet.

Your connection leads will

have a white or black plug for left, and a

red plug for right.

PHONO GROUND TERMINAL

The Ground Terminal is for you to

connect ground wire of your turntable in

order to eliminate possible interference

and hum loop for best possible sound

quality.

PHONO MM/MC INPUT SELECTION

SWITCH

3. PHONO INPUT (OPTION COAXIAL

IN)

This input is suitable for both moving

magnet and moving coil cartridges. For

either type of cartridge the plugs on your

turntable lead should be connected to the

phono input sockets on the rear panel of

your amplifier.

switch

adjacent

input sockets allows the selection of

either MM or MC input. Facing the

back of the amplifier, move the switch

to the right for use with MM or high output

MC cartridges and to the left for use

with MC cartridges.

Note: Never operate the MM/MC selector

switch with the volume control turned up

as the resultant electrical surge may

damage your loudspeakers.

To minimize hum the turntable lead

should be kept away from the mains

wiring, and any separate turntable ground

lead should be attached firmly to the

earth terminal on the rear of the amplifier.

4. OPT/ USB / AUXILIARY INPUT

The OPT /USB /Auxiliary input is designed for using

with Optical (OPT) or USB input located at Top Left

corner of rear panel for Hi-Res Streamers like D-

STREAM PRIMO-HD etc or and other optical

sources or for any extra source processing a line

level output, perhaps a second tuner or CD

player, or an additional tape or video recorder

wired for replay only.

Use OPT input only. for using AUX inputs, please

take OPT or USB output connector out from

CN201

5. TUNER INPUT

The Tuner input is suitable for use with most AM/

FM tuners. Connect your tuner to the amplifier

using the RCA sockets marked

"Tuner".

6. CD INPUT

The CD input is suitable for use with any CD

player. Connect your CD player to the amplifier

using the RCA sockets marked "CD".

7. PRE OUT 1

There are two pre-outs, PRE-OUT 1

& PRE-OUT 2 for the convenience

to have the pre-amp outputs to be

connected to more others equipments.

the

RCA

The two pre-outs are connected in

parallel together.