Floe VSD 5000 Montaj Talimat Kılavuzu - Sayfa 8

Çadır Floe VSD 5000 için çevrimiçi göz atın veya pdf Montaj Talimat Kılavuzu indirin. Floe VSD 5000 12 sayfaları. Pontoon guide-in/bunk
Ayrıca Floe VSD 5000 için: Montaj Talimatı (4 sayfalar), Montaj Talimatları Kılavuzu (8 sayfalar), Montaj Talimatları Kılavuzu (8 sayfalar), Montaj Talimatları Kılavuzu (12 sayfalar)

FOLLOW THESE GUIDELINES FOR USING AND LOCATING THE PONTOON BUNKS (FIGURE 2.5A & 2.5B).

-THE WIDTH OF THE BUNKS SHOULD BE 1-2 INCHES LESS THAN THE DISTANCE BETWEEN THE

PONTOONS.

-TO SET BUNK HEIGHT, MEASURE FROM THE BOTTOM OF THE PONTOON DECK TO THE BOTTOM OF

THE PONTOON, THEN ADD 1" TO THAT MEASUREMENT.

-THE REAR OF A 21 FOOT PONTOON BOAT SHOULD OVERHANG PAST THE LIFT BY 3 FEET. FOR EVERY

ADDITIONAL FOOT IN LENGTH OF THE BOAT, IT SHOULD OVERHANG BY AN ADDITIONAL 6 INCHES

BEYOND THE REAR OF THE LIFT.

THESE ARE THE GENERAL GUIDELINES THAT CAN BE ADJUSTED FOR AN INDIVIDUAL'S

CIRCUMSTANCES.

ONCE FINAL POSITION IS SET, TORQUE 3/8" NUTS ON CLAMPS TO 35 FT-LBS (FIGURE 2.6).

FIGURE

2.5A

UPRIGHTS MAY HAVE TO BE CUT TO

ALLOW FULL TRAVEL OF CRADLE ONCE

FINAL PLACEMENT IS ESTABLISHED.

NOTE:

SHEET 8 OF 12