Flomec G Series Ürün Sahipleri Kılavuzu - Sayfa 7

Ölçüm Cihazları Flomec G Series için çevrimiçi göz atın veya pdf Ürün Sahipleri Kılavuzu indirin. Flomec G Series 20 sayfaları. Industrial and chemical models
Ayrıca Flomec G Series için: Kullanıcı El Kitabı (16 sayfalar), Ürün Sahipleri Kılavuzu (20 sayfalar)

Sayfayı Yazdır

Replacement Kits

A replacement kit is comprised of all the internal component parts within the turbine

flowmeter. A replacement kit consists of the following:

FLOMEC Sanitary Turbine supports are not identical in design. The rear support

assembly has a shaft that supports the rotor; the front support does not.

Notice that the direction of flow is displayed on the body of the turbine flowmeter.

This is important when installing the supports and rotor and it also denotes the

direction in which the turbine flowmeter was calibrated.

1. Install the front support placing a vane between the notches in the turbine

flowmeter body. Install a retaining ring to keep the support in place.

2. Place the rotor assembly on the shaft of the uninstalled rear support assembly.

NOTE: FLOMEC Sanitary Turbine rotors are tapered on one end. The tapered end

should be installed facing the front support (see Figure 1).

Figure 1

Parts Description

Rotor Assembly

Support (Front)

Support Assembly (Rear)

Retaining Ring

Quantity