Ameda PENGUIN Kullanım Kılavuzu - Sayfa 14

Yiyecek Isıtıcı Ameda PENGUIN için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Ameda PENGUIN 16 sayfaları. Deluxe nutritional warmers

Ameda PENGUIN Kullanım Kılavuzu
13. EMC INFORMATION
THIS ELECTRICAL EQUIPMENT needs special precautions regarding EMC and needs to be installed and put into service according
to the EMC provided in these Instructions for use. Portable and mobile RF communications equipment can affect this ELECTRICAL
EQUIPMENT. Warning: Portable RF communications equipment (including peripherals such as antenna cables and external antennas)
should be used no closer than 30 cm (12 inches) to any part of the Penguin Nutritional Warmer, including cables specified by the
manufacturer. Otherwise, degradation of the performance of this equipment could result. Warning: Use of accessories, transducers
and cables other than those specified or provided by the manufacturer of this equipment could result in increased electromagnetic
emissions or decreased electromagnetic immunity of this equipment and result in improper operation. Warning: Use of this
equipment adjacent to or stacked with other equipment should be avoided because it could result in improper operation. If such use is
necessary, this equipment and the other equipment should be observed to verify that they are operating normally.
Guidance and manufacturer's declaration – electromagnetic emissions
The Ameda Penguin Warmer is intended for use in the
electromagnetic environment specified below.
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/flicker
emissions IEC 61000-3-3
Guidance and manufacturer's declaration – electromagnetic immunity
The Ameda Penguin Warmer is intended for use in the
electromagnetic environment specified below.
Immunity test
Electrostatic discharge
(ESD) IEC 61000-4-2
Electrical fast transient/
burst IEC 61000-4-4
Surge IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power
supply input lines IEC
61000-4-11
Power frequency (50/60
Hz) magnetic field IEC
61000-4-8
NOTE U
is the a.c. mains voltage prior to application of the test level.
T
Compliance
Group 1
Class B
Class A
Complies
IEC 60601 test level
± 8 kV contact
± 2 kV, ± 4 kV, ± 8 kV,
± 15 kV air
± 2 kV for AC line; 100
kHz repetition frequency
± 0,5 kV, ± 1kV line-to-
line; ± 0,5 kV, ± 1kV,
± 2kV line-to-ground
• 0% U
; 0,5 cycle At 0°,
T
45°, 90°, 135°, 180°,
225°, 270° and 315°
• 0% U
; 1 cycle and 70%
T
U
; 25/30 cycles
T
Single phase: at 0°
• 0% U
; 250/300 cycles
T
30 A/m
50 Hz or 60 Hz
The customer or the user of the Ameda Penguin Warmer should
assure that it is used in such an environment.
Electromagnetic environment – guidance
The Ameda Penguin Warmer uses RF energy only for its internal func-
tion. Therefore, its RF emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
The Ameda Penguin Warmer is suitable for use in all establishments,
including domestic establishments and those directly connected to the
public low-voltage power supply network that supplies buildings used
for domestic purposes.
The customer or the user of the Ameda Penguin Warmer should
assure that it is used in such an environment.
Compliance level
± 8 kV contact
± 2 kV, ± 4 kV, ± 8 kV,
± 15 kV air
± 2 kV for AC line; 100
kHz repetition frequency
± 0,5 kV, ± 1kV line-to-
line; ± 0,5 kV, ± 1kV,
± 2kV line-to-ground
• 0% U
; 0,5 cycle At 0°,
T
45°, 90°, 135°, 180°,
225°, 270° and 315°
• 0% U
; 1 cycle and
T
70% U
; 25 cycles
T
At 0°
• 0% U
; 250 cycles
T
30 A/m
50 Hz
14
Electromagnetic environment – guidance
Floors should be wood, concrete or ceramic tile.
If floors are covered with synthetic material, the
relative humidity should be at least 30%.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment. If the user
of the Ameda Penguin Warmer requires continued
operation during power mains interruptions, it is
recommended that the Ameda Penguin Warmer
be powered from an uninterruptible power supply.
Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.