American Recorder AllCast MULTI-FUNCTION MONITOR STAND Manuel - Sayfa 7

Raflar ve Standlar American Recorder AllCast MULTI-FUNCTION MONITOR STAND için çevrimiçi göz atın veya pdf Manuel indirin. American Recorder AllCast MULTI-FUNCTION MONITOR STAND 8 sayfaları.

Sayfayı Yazdır
STEP 7
STEP 7a - Assemble MONITOR ARM onto the pole as shown and
secure by tightening arm support bolt with 6mm Allen Wrench Key.
MONITOR ARM
STEP 7c - Place WEBCAM BRACKET on RING
LIGHT PLATE
STEP 8
STEP 8a - Place microphone in cradle and fasten
threaded knobs. Hand tighten only. (run USB-C cable
into mic and run cable along arm to USB-3.0 hub)
ALLCAST MULTI STAND OWNERS MANUAL ver2.0
Saturday, February 20, 2021 3:05:57 PM
INSTALL SINGLE MONITOR MOUNT
INSTALL DUAL MONITOR MOUNT
Ring Light & HD Webcam Mount
INSTALL SINGLE MONITOR MOUNT
INSTALL DUAL MONITOR MOUNT
Attach Microphone & Light Controller
STEP 8b - Place rubber controller
holder and grip onto mic cradle
GRIP
7
STEP 7b - Attach RING LIGHT/WEB CAM PLATE to
monitor arm. Fasten with thumb knob.
STEP 7d - Attach 6" RING LIGHT to base of RING LIGHT PLATE and thread
with 1/4"-20x0.40 thumbscrew. Attach HD WEBCAM to upper base of
WEBCAM BRACKET, fasten with 1/4"- 20 x 0.25 thumb screw (run Webcam
and light cable down back of stand to base, use round clips to secure).
1/4"-20 x 0.25"
THUMBSCREW
1/4"-20 x 0.40"
THUMBSCREW
STEP 8c - (Run RING LIGHT & MIC USB cables
from base of stand to front of mic arm, use
rectangle clips to secure wire). Insert light
controller into rubber boot.
LIGHT
CONTROLLER
BOOT
WEBC AM
HD FULL
100
95
75
25
5
0