American Safe Room ASR-200-AV-NBC Safe Cell Kurulum ve Kullanım Kılavuzu - Sayfa 6

Hava Temizleyici American Safe Room ASR-200-AV-NBC Safe Cell için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. American Safe Room ASR-200-AV-NBC Safe Cell 19 sayfaları. Nuclear, biological, and chemical overpressure filter system

Sayfayı Yazdır

Wall mounting

The mounting location should be near an electrical outlet and within reach of the air inlet (the wall

mount flange or the intake blast valve). If the air intake hose will not reach the bottom air intake

port on the Safe Cell, 4 inch, schedule 40 ABS pipe and fittings should be used to connect the hose

to the air inlet. The air intake hose will slip fit onto a 4 inch pipe with an outer diameter of 4½

inches.

The Safe Cell needs to be mounted in a vertical position as shown below, unless a special carbon

adsorber is supplied that has internal baffles to mitigate the possibility of blowby if the carbon

settles. For ease of manual hand crank operation mount the Safe Cell to the wall with the bottom

sitting on the floor. The complete mounting system is first assembled on the Safe Cell so that the

fastener holes can be located on the wall. One end detail is shown below, the other end mounting

arrangement is identical:

1. Assemble the clamp bars (item 5, below) to the Safe Cell by inserting them between the

top and bottom end bell flanges and sliding the threaded rod (item 1, below) through the

tubes and threading on the flange nuts (item 2, below).

2. Assemble the wall mount brackets (item 3, below) to the clamp bars (item 5, below) and

tighten down the star nuts (item 6 below) .

3. Put the Safe Cell in place on the floor with the wall mount brackets up against the wall.

4. Locate and mark the center of the hole locations for the wedge anchors (item 4, below).

5. Remove the Safe Cell. Drill the holes and install the wedge anchors. See page 19 for wedge

anchor instructions.

6. Remove the wall mount brackets from the clamp bars and assemble them onto the wedge

anchors and tighten the nuts.

7. Assemble the Safe Cell to the wall mount brackets and tighten the star nuts.

Figure D-1

ASR-200-AV-NBC Safe Cell

Installation and Operation Manual

Revision C - April 27, 2016

Section

Page 6