Canon CR-X500 2A Kullanım Kılavuzu - Sayfa 8

Dijital Kamera Canon CR-X500 2A için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Canon CR-X500 2A 25 sayfaları. Remote camera

Installing a lightning rod

If precautions need to be taken against lightning in case the system is to be installed on a hill-top

or other such location, provide a lightning rod as shown in the figure.

Make sure that the system will not touch the lightning rod when the camera is panned.

In the case of a permanent installation, safety is further enhanced by providing a lightning-proof

transformer for the system's power supply.

In case a safety wire is necessary for the pan-tilt head, make sure to attach the wire to the handle section. When attaching the wires,

be careful that nothing blocks operation of the pan-tilt head.

Inspect the waterproof connector for looseness. After passing each cable through the waterproof tube and the waterproof unit, insert

the waterproof tube all the way into the waterproof connector until its tip touches the end and secure it in place. Put the end of the

waterproof tube in a safe place so that water, dust and moisture do not enter. Also, do not seal the end of the waterproof tube so as

to mitigate a pressure rise inside of the product caused by the temperature change. Connect each cable to the receptacle unit of the

main unit, and then secure the waterproof unit to the pan-tilt head using the supplied mounting bolts (x4).

Clamp the cables at appropriate intervals.

Waterproof unit

mounting bolts (x4)

Fall prevention wire

(for waterproof unit)

Waterproof connector

Waterproof tube (L = 500 mm)

RohrFlex: RF-36 FLEXA

Receptacle unit

Waterproof unit

45°

Lightning rod